V-minion BTT mini 12864 display case adjustable REMIX (T-slot compatible)

This is just a simple remix that lets you tilt the display upwards instead of being in a fixed position. If your printers table or desk sits lower than average you can tilt the screen with this mod.

Requires: (in addition to the original BOM)

• 1 M3x20mm (up to 27mm) bolt 
• 1 M3 nut

Original BOM:

• BTT mini 12864 display.
• x6 M3 heat inserts 5mm OD, 4mm length.
• x4 M3x8 screws.
• x2 M3x12 screws.
• x1 M6 T-slot nut. (M5 works as well)
• x1 M6x12 screw.  (M5x12 works as well)

Attach "Remixed-Mount-rear.stl" to your printer's extrusion before assembling.

Slide the M3 nut into the pocket from the top and bolt the front ("Remixed-Mount-front.stl") and back together from the side.

Relief cuts allow for some tightening so that the display doesn't just drop down.

Lift the display so it's facing straight up to bolt the assembled display to the mount.
 

All original files included.

Enjoy!

This remix allows for tilting the display up varying degrees for printers that might sit on desks that are a little lower.