Hikvision DS-KV6113 doorbell bracket (45 degrees)

Bracket for mounting Hikvision doorbell camera with 45 degree angle, intended to be mounted in a corner.

Can be mounted left or right.

Print settings: 0.2mm layers, 20% infill.
I printed in silver PLA to (roughly) match the camera's silver back.

In order to get nice layer lines, it's best to print it 'face down' (i.e. the side where the original black metal bracket needs to go in). This means you'll need to add supports for all of the recessed edge.
Be careful not to print supports inside the screw holes though (or be prepared to drill them out afterwards). I used PrusaSlicer's support painter to remove the unwanted support areas.

Feel free to customize the FreeCAD model if needed. Probably use the v2 model as a base, the v1 model is really tricky to customize.

Update 20211208:

• Added v2 design, which is a complete redesign of the first to allow for easy changing of certain parameters (most notably tilt angle).
• Tilted up 10 degrees by default.

Note: commercial use is not permitted, contact me if you want a license.

(This was originally published to Thingiverse: https://www.thingiverse.com/thing:4882190)