Dolphin - Gopro cage Insta360 Go3

I was searching an esay way and protective way ton install my new Inta360 Go3 in my AtomRC Dolphin. Instead of installing it on top where it is exposed and impact the aire flow, I decided to insert it in the Gopro slot in the Dolphin nose, with the adapted cover.

It can easlily be slide in, and the TPU make it stay in place. With the camera Ultra FOV, you need to cut a bit the PEP cover. I recommand to tape que cover because the magnets will not be enough to keep everything in place in case of crash.

 I did not make any hole for the microphones. I am used to record with an O3 and using music on my videos, so did not care about the sound.

The good news with the Insta360 Go3 is that, even installed in, you can control it with the InstaPod. So you don't need a contact with the camera to start recording and all.

Print Settings

Printer Brand:

Prusa

Printer:

mk3S

Rafts:

No

Supports:

Yes, organic

Resolution:

0.20mm

Infill:

10%

Filament: eSun TPU 95A