Gimbal ring feet (25mm)

Model
Feet for a 25mm gimbal ring. Print top half pieces on their edge.

Parts needed

• 4x - ¼"-20 1" Long SHCS screws
• 4x - 3/8"-16 to ¼"-20 Thread adapters

Installation - (Please see photos for guidance)

Screw 3/8"-16 to ¼"-20 Thread adapters into 3/8"-16 holes, place printed clamp on top and screw it down as tight as possible. Make sure to adjust the tilt of the ring so it does not fall over.

Print Settings

Supports:

May help for overhangs.

Resolution:

0.12mm

Infill:

30%+

Perimeters:

Ideally 8x plus.

Filament: CF PLA, PC / PCCF, Nylon or any other sturdy filament.