Naruto - Kyubi mode - HueForge

Here is the PrusaSlicer version I used on my Prusa MK4 with MMU3. You can use the recommended 3MF or STL with the manual print instructions below.

Manual print instructions

Print at:

• 100% infill
• Layer height: 0.08mm
• First layer height: 0.16mm
• Ironing: 15%

Filaments Used:

• Polymaker PolyTerra PLA+ Black
• Prusament Orange
• Polymaker PolyTerra PLA Savannah Yellow
• Polymaker PolyTerra PLA Cotton White

Swap Instructions:

1. Start with Black
2. At layer #12 (1.04mm) swap to Orange
3. At layer #18 (1.52mm) swap to Yellow
4. At layer #20 (1.68mm) swap to White for the rest

PrusaSlicer version