Ubiquiti Unifi Cloud Key Gen2 Plus wall holder

Most mounts I could find for the Cloud Key Gen2 variant involve two brackets, both of which are screwed down. I want to be able to remove the cloud key without the use of a screwdriver and with as few holes drilled into my walls as possible. This model is more of a pouch with a tight fit that the key rests in, avoiding most of the downsides mentioned above. 

Designed to be used with screws with a diameter of 3-3.5mm, screw head ≤ 7mm, 80mm apart. 

Print recommendations: 

• ≥20% infill
• Ensure that you a good first layer, the model is prone to warp due to the relatively thin walls.
• You may have to flip the model on import.