Drill spool winder - No screw - Any width - Lightweight - Quick print - Printable Hex Bit

Maturity: Very good.

• 10 prototypes.
• In use since 2024/06.

A spoolwinder easy an fast to mount on a drill. There is no screw. It fits an 6mm hex bit.

The spool winder is for any spool hub in the range 50-55mm.

I found annoying to search for the proper hex bit each time. Then I decided to print one that stay in place in the spoolwinder. Print the one that fits best in yours (5.7mm to 6.0mm available).

Printing advise:

• Layer height 0.3 is enough
• Lighting infill is enough
• PLA is good enough
• Nozzle 0.4 or 0.6
• There is two configurations. “With pads” and “Without pads”. Take the “With pads” configuration if you fear you may have bed adhesion issues on small areas or as an insurance.

Log:

• 2024/06/15: Initial release
• 2024/10/01: Printable Hex bit added.