Plant Support for rod (parametrized ⦰, default ⦰ 1cm)

Different sizes of supports and forms for plants that uses a ⦰1cm rod. 

The clamp system and the opening in the front allows to easily install the support to the plant.

The clamps are designed to be stackable. This allows to have multiple different rings above each other.

Parametrized Version available

Need a different ⦰? Create your own custom support with the fully parametrized Fusion 360 .f3d File available for your custom plant support.

Print Instructions

Prints without any support. I printed with 40% triangle.

Hardware

The clamp height in total is 16.6mm. Therefore you need a 20mm M3 Screw for the back and a at leas 8mm M3 screw for the front.

Tipp: screw from the “lower” clamp side to have better access to the screw

Changelog

2024.06.23: added endpieces, reupload double support versions to fix missing fillet

Added rings to the clamp for plant support.