Christmas Ornament Candy Dish

I was asked to design a Christmas ornament candy dish. This is what I came up with. It came out way better than I ever thought it would have.  It prints very well even without supports!

I am even filling them with candy canes and other candies to give out as gifts and people love them.

Print Settings:

• ORNAMENT - .8mm nozzle at .4mm layer height (this works great with .4mm nozzle and .2mm layer height but takes MUCH longer)
• CROWN, CLIP and HOOK - .4mm nozzle at .2mm layer height
• 15% Infill
• Prints great with PLA and PETG
• No supports needed

Assemble:

• Put the crown on first
• Squeeze the clip together and put it through the holes of the crown.
• Then snap the small part of the hook onto the clip thats in the crown.

Tips:

• Here is a link to a video on how to put the clip in the crown. 

• If the clip breaks, then print it last and take it right off the print bed as soon as it finishes and squeeze it or you can use a heat gun.

Thank you to @Dadof6 for this video showing them being printed: https://www.instagram.com/p/CXKngN9FMS8/