Icom 7300 rails

Reupload of the 7300 side rails designed by IU1OPK. No changes made as per original license.

Print them standing - if you print them horizontally, the side forces you are protecting your rig against can easily cause layer delamination. 

Printing took around 18 hours, but sanding wasn't a 10 minute job either. On a MK3 print bed, you can print the whole thing diagonally with a smaller brim or no skirt. I printed mine in ASA, 50% infill. I planned to sand it down, so I went with 4 vertical shell perimeters.

BOM:

• 8 pcs, M4x10
• 8 pcs, M4 washers