Anger - Inside Out - Hueforge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x193.79mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA Basico Control3D Black Transmission Distance: 1.6
PLA Overture Chocolate Transmission Distance: 0.2
PLA Basico Control3D Red Transmission Distance: 4
PLA Sunlu Meta Grey Transmission Distance: 3.5
PLA PolyTerra Sunrise Orange Transmission Distance: 2
PLA Basico Control3D White Transmission Distance: 1.2
This print uses 6 unique filaments

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Chocolate
At layer #11 (0.96mm) swap to Red
At layer #14 (1.2mm) swap to Grey
At layer #20 (1.68mm) swap to Sunrise Orange
At layer #25 (2.08mm) swap to White for the rest.