TTRPG - Mini Holder for PolyMaker Box

A Mini holder print for polymaker cardboard box with 23 slot

good for minis with a normal sized (25mm ) and beveled base 

only default is each minis need to have the same base size or the smaller base one might not be secured tight enough

Printed in PLA at 0.2mm and 25% infill, No support needed

2 rubber band needed

assembly : 

first glue the pin on the lock part like so (pin on the top face of lock part) : 

put the two part together, and check if it slide well : 

If you want the lock to open a bit more you can sand this part (in red) to add more travel length for the peg

now i use super glue to fix the base part to the polymaker box like so : 

i apply super glue like this (red dot), just pay attention to not glue shut the sliders ( here the grey part)

You can now use the rubber band on the peg like so ( you do not need super strong rubber band, just enough to maintain a slight pressure) : 

and now you can store your mini and they will never fall :)