Bondtech V2 LGX Lite extruder housing for motor sandwich mounting

The original Bondtech LGX Lite extruder has recently been superseded by the new V2 version and has a two part body in place of the original four piece. Unfortunately the V2 two part body can no longer be used with many custom mounts as Bondtech has removed the ability to sandwich mount it with the motor.

This model is a replacement rear extruder housing for the new version V2 LGX Lite. The rear is cut off to make it the same depth as the original V1 with the back plate removed and thus allow it, once again, to be sandwich mounted with the motor using the many custom brackets already available.

Print recommendations.

Material ABS or ASA.

Print & bed temperature: as per filaments manufacturers recommendations.

Set Chamber temperature to 50oc

Nozzle: 0.4mm

First Layer: 0.2mm

Layer height: 0.1mm min - 0.16mm max

Vertical shells: 5 (2.0mm)

Bottom & Top horizontal shells: 20 (2.0mm min)

Infill: 30%

Fill pattern: Cubic

Material Flow Ratio/Flow Ratio/Extrusion Multiplier: 0.975 (within the filament settings)

Support Settings: Grid or Zig Zag, Overhang threshold 5 degrees

Perimeter Generator: Arachne

Perimeter/Wall Transitioning Threshold Angle: 45 degrees

Cooling: (within filament settings)

Keep Fan Always On, minimum speed 14%, 50% max.

Slow down if layer print time is below: 25s