16mm Tube Clip with Thin Filament Guide - Set of 5

UPDATE 5/6/2025: I printed this in PETG with 100% infill and the durability went up tremendously. The PLA versions held pretty decently but started to break down a bit over time and with usage. The PETG versions are much stronger and I think will hold better over time.

Adding the bgcode file for PETG.

ORIGINAL:

This was printed on my MK4 using Prusament PLA color “My Silverness” at 100% infill with 3 perimeters. I used supports for the guide and printed it on it's side to reduce the print time and support stability in the model.

I've added a low-profile filament guide to the clip and reduced the width of the clip to align with the guide.