Nice looking guitar hanger with a robust thickened wireframe structure.
Can be screwed to a wall qith 3x 4mm screws.
Guitar neck widths available: 44, 46, 48, 50, 52, 54 mm
My classical guitar has a 52mm neck so I used that one.
Always chose the dimension that is equal or slightly higher than the neck of your own guitar.
I have tested it for a classical guitar an it works perfect. If you have an electrical guitar, please do some tests before you leave your guitar there hanging to ensure the print is strong enough, as they are a little heavier.
If you need some change/customization just tell me and I can change and add the needed model.
Printer Brand:
Creality
Printer:
Ender 3
**Rafts:** NoSupports:
No
**Resolution:** 0,2Infill:
30
**Filament:** [ Clas Ohlsson PLA ](http://www.amazon.com/s?url=search-alias&field-keywords=Clas+Ohlsson+PLA&tag=thingiverse09-20) AnyNotes:
I printed this hanger with a very thick wall, around 1.5 mm, and I was impressed by the stiffness and strength you can get out of PLA. In this case I think the wall thickness plays a bigger role than the infill.
Post-Printing ============= For extra protection, it can be good to add auto-adhesive felt tabs (those you put under the furniture to avoid damaging the floor) or a piece of fabric on the area that will be in contact with your guitar. Category: MusicAutor oznaczył ten model jako własne oryginalne dzieło. Zaimportowano z Thingiverse