Mailbox Lid Door Hinge Pin and Washer

My Mailbox Lid broke! Just the pin really, but surprisingly you can't replace this single part? The cheapest I could find in mid-2024 was a $26USD full door replacement, that sucks! 

I modeled a replacement pin and washer. The dimensions are changed a little bit so that the model could be printed in PETG instead of something more flexible. The fit is great though!

Some printing tips, don't print the pin vertically, which will place mechanical stress on the layer lines during use. There is a Reddit post of someone doing the same thing and his only lasted 3 days... Print on a diagonal angle and use thicker shells. You don't have to print the pin with 100% infill, but the time/cost is negligible, so you might as well.