ESP32 Camera Lense covers

These are simple lense covers for the Esp32 camera case by Michal Fanta recommended in the Prusa ESP32 camera Development diaries.

Unplugging/plugging in the camera for privacy reasons was not suitable for me.   I designed the simple cover with a light interference so it snaps on and off easily. 

There are standard and thin versions with holes on top to allow ventilation.

11/15/2024 a standard version for when the camera is mounted upside down was added. 

.stp files also provided it you want to do more. 

I used PETG, but any filament will do.  I recommend 4-5 profiles.   About 26 minutes on an MK4.

If the fit is too tight or loose adjust the scale for that axis in the slicer.  In the provided slicer, it is Y axis.   Approximately 0.45% per .1mm adjustment.   Designed interference is 0.5mm.    If you want a .3mm interference, Y adjustment would be 100.9%