Dual Ocarina stand for Soprano C and Alto C ocarina designed by E.C.3D

Dual Ocarina stand for Soprano C and Alto C ocarina designed by E.C.3D

https://www.printables.com/model/845214-ocarina-sc

https://www.printables.com/model/474058-ocarina-of-time-12-hole-alto-c-ocarina

I've printed many ocarinas here, but E.C.3D's design is the best. So I made a stand for E.C.3D's Soprano C ocarina and Alto C ocarina.  

This stand only fits 

oc_oot_12h-ac_Version-3_no_triforce.stl

and  

oc_sopranoc_clean.stl

I designed this stand to make a great gift to friends. 

I HIGHLY RECOMMEND printing this upside-down, so that the lettering side is the initial layer. As you can see on my last two photos (failure prints), letterings will become blurry if its the top layer.

I printed with PLA, 0.3/0.6mm, with support, 2 walls, 3 top and bottom layers, 25% lightening infill. I also printed with white PETG, but I guess flat white PLA looks better. USE lightening infill to save filament and printing time.