(Thinner) Sheba Chute

I did a poor job printing the original and wanted to have another go at it since my overhangs came out really bad (printing way too fast).

With this reprint, I wanted to optimize the wall depth a bit and make it fit on my counter better.

I painted on tree supports for the bottom area and printed the top upside down. The two should fit together pretty easily as I left a 0.2mm gap around the entire edge – a bead of CA glue should keep the sides held together nicely.

• Thinned outer wall for 4 perimeter printing
• Split viewing window into two sections to keep separate prints more stable
• Added a small chamfer to the back edge to it can slide up against counter top silicon bead without coliding
• Did not remodel the wall hanging hook-holes