Ender 5 S1 additional bed support - 12mm Rod - Redrawn
Description
PDFUses
(10) M4 x 12mm SHCS
(2) M4 x 30mm SHCS
(2) M4 x 25mm BHCS
(8) #2-28 x 1/2” Long Screws For Plastic
- https://www.amazon.com/gp/product/B00GDYGDTY/ref=ppx_yo_dt_b_asin_title_o03_s01?ie=UTF8&psc=
(2) LM12UU Linear Bearings
(2) 12mm OD x 425MM Long Linear Rod (I bought 450mm long and cut it with a grinder cut off wheel)
(12) M4 T-Nuts
Changes:
- Shorted Upper Rod Supports and changed the fillet to allow you to use the belt and POM wheel setup that comes with the ender 5-S1.
- Note: the original was very close on clearing when actually printing. Now though mechanically the fan can not hit no matter what.
- Made rod bearing holder a little thicker for the screw for plastic. I also added little tiny ledge that match the LM12UU Linear Bearings I bought to mechanically trap them in place. [I used a screw driver to open the slot up to allow me to insert them.]
- Used screws for plastic instead of a regular metric bolt since I do not like threading regular bolts into plastic.
- Made all the shorter bolts the same length
- Used M4 bolts on the bearing support arms instead of M5 for mine.
- Changed Lower Rod Support to allow the Creality enclosure to sit flush
Directions:
Import the 3 files into your slicer, duplicate and mirror a set along the x axis.
When Installing the upper rod supports chamfers face up, and the lower rod supports face down.
Parts are best printed in ABS, use 30-40% infill for linear bearing holders, use 100% infill for steel shaft supports.
Updates:
6-6-24 - Fixed the lower rod support in v1.4, I made it shorter in v1.3 to clear the enclosure panel, but was in a rush and didn't check the bolt to rod center distances.
Added a M5 bolt hole Version for the bearing rod arm.
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
Shorted Upper Rod Supports and changed he fillet to allow you to use the belt and POM wheel setup that comes with the ender 5-S1
