Burette and pipette stand

About

This is a simple functional stand for burretes and pipets with drain train for any laboratory. Its very easy to print and assemble. 

Expense 

How to print ?

When printing the connector place on the short tube of the connector or autobed it and it will do it automatically(shown on the photo bellow). Print connector with supports.

Assembly

Assemble the stand according to the sequential numbers in the files (and in the description below) or as shown in the picture.

Stand dimensions

Roughly, the dimensions of the stand are 204mm of the lower tray and the height of the connector is 226mm.

1. Tray : Ø 204mm 
2. Drain tray: Ø 180mm
3. Connector: Ø20mm h=226mm
4. Net: Ø180mm

Holes

The first circle has 15 holes with a diameter of 15 mm for larger burettes and pipettes, the second has 15 holes with a diameter of 12 mm and the third one with 10 holes and also with a diameter of 12 mm for smaller burettes and pipettes.

What kind of burettes and pippetes fit ?

The height of the connector below the joint is 206mm and above the joint is 22mm, so larger filling pipettes that have up to 200 mm to the belly also fit.