Magnetic Stir Base

A Magnetic Stir Base that is based around the GBM4008-150T motor.

Need the following:

• GBM4008-150T motor. (use included screws)
• 2x 14mm diameter be 10 mm magnets.
• A half size 6 inch deep steam pan.
• A speed controller such as https://www.amazon.com/gp/product/B09PV3R3JQ/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1
• A 24 volt power supply with at least 1 Amp of current.
• A magnetic stir / impeller such as this one by rsilvers:
  https://www.printables.com/model/207888-magnetic-stirrer-impeller

Instructions:

1. Print out of clear PETG.
2. Epoxy the magnets into the MotorMagnetAdapter and wait 24 hours.
3. Screw the MotorMagnetAdapter to the motor.
4. Hot glue the MotorMagnetCap over the MotorMagnetAdapter.
5. Screw the Motor into the MagneticStirBase making sure the wires go out the wire channel.
6. Wire the motor to the Speed Controller.
7. Wire the Speed Controller to the power supply.
8. Plug in the power supply.
9. Place steam pan on top of base.
10. Slowly turn on the magnetic stir to get magnetic stir up to desired speed.