I was looking around for 90 deg vent for tight spot for my Artisan and I could not find any.
The vent is to be used with the Snapmaker artisan original 3in vent and the vent clamp that came with.
The 90 degree vent is printed in about 6h and 40 minutes (.4mm). The material need is about 218.5g. I printed mine out of PLA and works just fine. There is no need to print with support.
The holes are slightly off so what I did is redrill the holes that the artisan Plexiglas came with slightly bigger with a drill bit and work fine.
Also, I use tap to make the treats for the screws. I don’t think you need to use tap just with any screw will work.
The author marked this model as their own original creation.