Motor mount for 6384 and Flipsky waterproof on KT foil or any foil

Print Settings

PETG
height 0.2
no-supports
infill 20%
external perimeter first
perimeters 4
solid layers bottom 5 top 3
seam aligned
speed 80
no fan
bridge/overhange speed 10 fan 80%
width default 0.7 infill 0.5

Print settings for the fit pin

PETG
external perimeter first
nozzle 0.4
layer height 0.15
perimeters 9
solid layers 0
speed 10
fan 50%
extrusion width 0
temperature 260
 

Postprocessing

Connect with pins
Back bottom glued to the back top.
PETG glued with R21 thin glue.
PC uses acrylic glue.

Motor: 6384 from Aliexpress

Attached 3mf where you can remove the cable guide if you want to.
Attached also stl uncut.

Motor screws 4x M4 x 30
Screws to connect front and back: 2x M5 x 16  + Inserts: 2x M5

Foil-Assist build:
https://foil.zone/t/assist-build-from-israel/20173

1. Cut for KT mast
2. Added eyes for vertical holes for better print
3. A bit longer to accomodate wider mast
4. Screws base is flat.
5. Cable guide is tighter, will hold 12AWG cable by tight fit
6. Ready to fit with pins and glue