Flashforge Adventurer 5M Pro Rubber Foot

I printed this using two different processes, so the top part (the side touching the printer) was denser (40% infill) and the bottom part (the side touching the table) was less dense (15%) so it would be softer. They are also 5mm taller than the stock feet. They are a direct replacement and require no additional hardware. Unscrew the existing feet and then screw in the new ones.

Disclaimer: I have an early FFAD5MP and do not know if they changed the design later. These feet work with my model of FFAD5MP,  but YMMV.