(NON-Chonki) BoboVR XL Long Koss Headphone Adapters

This model is a remix of ZincLeadAloy_1332620 ‘s model of “BoboVR XL Long Koss Headphone Adapters (Chonki)”. This model allows the same extension of the headphones but also includes the standard ’needle nose plyer' like mount that the “Sturdy Meta Quest 3 and Quest 2 Headphone Mount” includes. I had found that the Chonki mount was actually too Chonki and was not allowing me to properly mount my Koss headphones to the clips. I also have changed the orientation of the mount so that it lets you swivel the headphones forward and backwards like on the original model. 

Print with standard 15% infill with PETG. I would highly suggest getting the plastic slightly warm for a brief moment (5 or 6 seconds) under a heat gun before pushing the headphones into the mount. This time changes based on the temperature of the heat gun, but I had mine at 245 for that time. 

The “Sturdy Meta Quest 3 and Quest 2 Headphone Mount” was too short for my head and sat too far back on the BoboVR headset. These were the changes that the “BoboVR XL Long Koss Headphone Adapters (Chonki)” model corrected. I replaced the Chonki mount with the standard 'needle-nose pliers' style mount that came with the original model and adjusted the mount's direction for a better fit.