Neon Benchy

June's Endless PLA subscription is out now! Since 4 of the 6 filaments are transparent we have decided to make some light inspired designs!

This Neon Benchy was inspired by the original Benchy design that you can find here: 3DBenchy

Print Settings

Rafts:

Doesn't Matter

Supports: 

No

Resolution:

.2mm

Infill: 

15-20%

Filament: 

Protopasta HTPLA 
 

Notes:

-0.2mm layer height
-15-20% infill

-No supports necessary

-I used this battery pack: Battery

-I used this wire: Wire

Print all parts (reference the IG reel for assembly)

-Cut EL wire tube to 30in ( 762mm) length

-Insert the battery pack into the bottom case

-Be sure to have the USB-C port face the hole on the case

-Be sure to have it lay with the button facing up

-Insert the rail through the top case hole

-Insert all of the tube through the top case hole

-Start with the end of the EL wire, start laying the EL wire into the rail at the “port hole” on the neon benchy

-Cap the rail with the rail cap

-Lay extra wire into the bottom case

-Snap the top case onto the bottom case

-Snap the neon rail assembly through the bottom case

-Plug a USB-C charger into the case and use the power button to turn on and off