Multi purpose door hook

This multi purpose hook can be adapted to all kind of doors due to its parametric design using attached OpenScad file. Generate your own personalized *.stl files, slice and print in less than 1 hour!

Good retention and permitted load with no need of screws. It can also be easily removed.

1.Download OpenScad here.

2.Open *.scad file included.

3.Set your parameters.

4.Previsualize/Render/Export to *.stl

Design Parameters

w: Door width

L: Hook Lenght

t: Thickness. A value of 1.6 mm worked fine for me but higher values might be necessary to increase overall hook strenght and resist higher loads. Bear in mind that higher thickness may interfere with your door frame as well.

i: Interference to improve hook retention on door. I used a value of 2.5 mm with very good retention.

Print instructions

Print at 0.2 mm layer height and set internal perimeters to 3 minimum. You may need to use supports if you include any label.

Printed fine in PLA but ABS or ASA probably will achive better strengh.