Just another wall mount

Hi all,
I'm sharing with you a this little new model.
I was in need of a wall mount for my mmWave sensor. The sensor itself is lightweight but not lightweight enough to be mounted in the classic ball joint.

So i designed this model with the following principles in mind:

• relatively easy to print
• adjustable on two axes
• no wall anchors
• discreet

This model is quite satisfying, enough to be used and published. I hope I can help other people in need to someting similar!

Required additional parts:

• 2x M3 bolt
• 2x M3x20 screw

Use an iron soldier to put the bolt on its place.

Slicer suggestion:

 In order to have a better quality and more solid print, please print all the pieces in a 45° angle. I'm posting a screenshot for a better understanding. if you use the support paint functionality you can add a little more support in the two base pieces, like me. The print will be much more solid (you'll avoid layer delamination when you are tightening the screw) and the joint will be more uniform.