Printed nice, but I would recommend redesigning with chamfers to avoid any supports
Apple Watch charger
Charger holder for Apple watch 6 large case.
284
3078
34
14 k
updated
November 30, 2021
Makes
Comments
Very nice! Thank you! Printed at 0.25mm, no brim, no supports, in PETG, with an enforced 70% around the bend as recommended. Very cool design, easy to print.
Works on my Series 10! Have to dial in my print settings but it works well!
Went ahead and printed with no supports. The horizontal cannel on the back didn't bridge well, but a little cleanup and it was fine.
Fits great! Probably did not need all the supports, but added them anyway. Thanks!
