Template - stick figures (v2, fixed)

Template for drawing stick figures.

Good bed adhesion is needed - PLA will need a well-cleaned plate and may be simpler to print with PETG.

The figure outlines are properly sloped so you can draw the figures accurately regardless of angle of the pencil:

Note: the OpenSCAD source can be reused to create another drawing template with properly sloped angles. Just replace the SVG with your own drawing and re-generate, optionally altering angle and template height parameters.

Changed in v2: Fixed non-optimal drawing angle that were generated at certain sharp edges within the template. The template now should be flawless.