Dicebox (keychain)

A keychain to hold your two favourite dice, so you can always play the games you enjoy wherever you are. Uses vasemode. If using PLA, the cord between the top and bottom might break. If so, cut it off, it's just to keep the both parts together but they should fit nicely. Made to fit two 16mm dice. 

Print with 0.4mm nozzle, 0.2mm layerheight. No support required. You can cut away the side wall, it's added to make vasemode possible. Prints in approximately 18 min. Tested with PETG on an Ender 3. Use vasemode!