Customizable Drawer Organizer for Spice Jars

If you use a lot of spices placed in a drawer, you surely face the fact that whenever you close the drawer, the spices get jumbled.  This system keeps spice jars in place and, thanks to its customizability, can be sized to ideally fill the drawer space.

The provided 3D models are ready for use with a flat-bottomed jar with a diameter 5 or 7 cm.

Print Tips

• 0.3mm layer height (but of course, can be lower)
• 2 perimeters, 15% infill
• no supports/rafts/brims
• (tested with ABS)

Additional Material

To connect the printed parts you will need 6mm-diameter rods (I used a hollow aluminium rod which is easy to cut)

• 45 mm long for 7 cm jars
• 32 mm long for 5 cm jars.

I recommend using good quality mounting tape to fix the parts to the bottom of a drawer. It is not necessary to fix all the parts, it is sufficient to fix the L-joint ones and the parts located in the centre of the grid.

If you're looking for the jars, I bought these:

• 5cm jars (20 pcs)
• 7cm jars (10 pcs)

Note

When fitting the rods into the printed parts, make sure that the rod is fully pressed into the hole, which is approximately 8 mm deep.