KitchenAid Toolholder

A fairly simple Toolholder for the standart 3 Tools/Attachments for the KitchenAid stand mixers.

even though i tried to design it to be as printable as possible, there are 3 little spots that need a bit of support. other than that it should be printable with any printer and material.

i printed mine with a 0.2mm layer height, automatic tree support out of Magenta Bambu ABS. ( i included the .3mf file with the settings i used for ABS )

you will need to get 6 little screws to attach it to i.e. the underside of a kitchen cabinet. they dont need to be very sturdy, i used some 2.5x15mm screws i found in our basement. make sure to not screw them in at an angle, otherwise the part will flex a bit away from the surface ( as seen in the photo ).