- remove the RAM mount ball by unscrewing the centre screw
- close the hole by screwing the screw back in or replacing it with a suitable M4 screw
- remove the 4 screws at the corners of the metal plate
- press 4 pieces of M3 nuts into the corresponding cut-outs of the printed upper part
- place the printed upper part flush with the 4 holes and fasten the upper part and metal plate with 4 M3x16mm screws
- position the holder on the bracket and screw the lower part to the upper part using 4 M3x20mm screws
Due to the heat load to be expected outdoors, it is essential to print with ABS, ASA or PA.
Tags
The author marked this model as their own original creation.