Lift Off

This is the “Lift Off” filament painting, showing a rocket during launch.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA BambuLab Basic Black
• PLA PolyTerra Charcoal Black
• PLA Overture Chocolate Matte 
• PLA Overture Brown 
• PLA PolyTerra Peanut
• PLA Ziro Skin
• PLA BambuLab Basic Jade White
   

Swap Instructions:

• Start with Black
• At layer #7 (0.64mm) swap to Charcoal Black
• At layer #9 (0.8mm) swap to Chocolate Matte
• At layer #11 (0.96mm) swap to Brown
• At layer #17 (1.44mm) swap to Peanut
• At layer #20 (1.68mm) swap to Skin
• At layer #25 (2.08mm) swap to Jade White for the rest.

Enjoy my work? Support me by joining my club. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.