Voron 2.4 Multi-Tool HEPA/Carbon Filtered Exhaust [Beta]

Exhaust housing, with carbon/HEPA filtering, to jam your multitool birds' nest into so we can pretend we have good wire management! Supports 2 to 6 tools.

BOM (not including what you should have from the stock 2.4:

• 2-6x Molex Micro-Fit 2x2 connector pairs and the associated pins
• A cup of Voron spec (M3x5x4) heatset inserts (16x+ ?)
• 1x Roomba 800/900 series HEPA filter
• NON-ACID-WASHED carbon pellets
• 8x m3x4 any cap screw
• 2x m3x8 any cap screw
• The rest of the wiring stuff that's probably really specific to your setup

Instructions:

1. Print
   • 1x Housing
   • 1x Housing cap
   • 1x Grate
   • 1x Lid (Rear cover) from WesPless' files
   • 1x Filter cartridge !!! WARNING !!! Scale it to 10% in slicer. I couldn't do it because my Fusion crashes when trying to scale it down. Working with .stl files sucks.
2. Heatsets
   • 12x into the housing
   • 4x into the back of the filter cartridge
3. Make your birds' nest & assemble in whatever order your heart desires
   • The female connectors go on the MCU-side and should slip snug into the grate. Fusion file available for modification
   • Make sure you use a non-acid-washed carbon
   • I prefer to insert the Roomba filter with the flag at the bottom

Might want to check these out too:

https://www.printables.com/model/885536-molex-microfit-2x2-strain-relief

https://www.printables.com/model/880095-btt-sb22092240-xt3022-replacement-shell

LICENSING

Yeah so while I want to, I can't give full rights because the remix sources are more restrictive. I give you full rights to do whatever you want to anything that isn't marked as remix in the files section since I made those myself.

Daniel's: Negated sections of the hepa/carbon adapter for wire routing, and I was having a skill issue with the top two corners (they don't make sense to me).

WesPless': Using the lid.