Wera Bit Holder

Wera Bit Holder

This print enables you to add additional bits to the Wera Kraftform Kompakt 60 (KK60) set. As delivered, the kit only contains one slot bit but I wanted to expand it to have more. So I designed this part which adds provision for 8 more bits. It is designed to clip onto the elastic in the middle section - see photos.

As well as the print, you will need to supply a length of elastic 25mm wide, 1mm thick and about 140mm long. I would suggest that you seal the cut ends using heat - I used a hot air soldering gun.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

No

Supports:

No

.150mm layer height

Infill:

15%