Filament roller for 90 degree angle Remix for (Un)original Prusa Drybox

Had some issues to get the filament down from my drybox to the printer since the drybox sits directly above it. I remixed this to fit the (Un)original Prusa Drybox. The PC-M10 fitting goes through the hole and then in the thread and holds it in place. I used 608 bearings. Since the bearing fit was a bit loose on the original bolt, i added a model “adapter.stl”. It's just a ring that goes inside the bearing. Everything was printed in green Prusament PETG filament. The Ring was just pushed on the bearing (quite a tight fit). 

Remixed for the (Un)original Prusa Drybox and added an adapter ring for a better fit of the bearing.