Extension Lead Desk Mount - Masterplug

These brackets are designed to hold a Masterplug extension lead on a desk for easy plugging of tools.  Designed to fit this style of extension lead and tested with the six socket version, though should work with the smaller ones assuming they have the same end style.  Has cutouts to expose the power and surge indicators.

The brackets are clamped to a desk from behind using standard g-clamps, and hold the power strip at 45 degrees above the desk, with clearance for cable management underneath.  The midspan support just sits there for longer extension leads to help support the middle of the span.

Print these on their sides - supports not necessary unless your bridging is just not working.  The only bridge will be at the back of the clamp, so not a critical piece if there's a bit of droop.  I printed at 20% adaptive cubic infill, 1mm top and bottom, and 3 walls.

Printed in a mixture of ABS and ABS+.  Was using up rolls, hence the Dennis The Menace colour scheme :P