Sponge Holder

A sponge holder for a two-parted sink. The bridge in the middle is 20-25mm, one side of the holder is 40mm wide, the other 60mm and it has a length of 120mm.

The one-sided version can be found here: https://www.thingiverse.com/thing:3936999

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK2 MMU

No

Supports:

No

0.2mm

Infill:

25% Rectilinear

Notes:

Be sure to print it standing up as shown in the picture to have it flexible and sturdy. Prints without support, don't enable supports in your slicer software or it might miscalculate some which are not needed.

Other Settings in Slic3r:

• First Layer Height: 0.2mm
• Vertical Shells: 2
• Solid Top/Bottom Layers: 3
• Seam Position: aligned
• All "Quality" Settings except "Avoid crossing perimeters"