Sponge Holder Single

This is a one sided version of my popular sponge holder for two-parted sinks. The bridge in the middle is 20mm wide, the basket is 60mm wide and it has a length of 120mm. Prints without support.

The double-sided version can be found here: https://www.thingiverse.com/thing:3363191

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK2S

No

Supports:

No

0.2

Infill:

25% Rectilinear

Notes:

Be sure to print it standing up as shown in the picture to have it flexible and sturdy. Prints without support, don't enable supports in your slicer software or it might miscalculate some which are not needed.

• First Layer Height: 0.2mm
• Vertical Shells: 2
• Solid Top/Bottom Layers: 3
• Seam Position: aligned
• All "Quality" Settings except "Avoid crossing perimeters" Printed in about 7.5h.