Modular Bathtub Tray/Organizer

This is a sturdy, easily accessible and infinitely extendable organizer for your bathtub corner with enough room to place all the shampoos, soap, gels and stuff for a whole family within reach where it's needed. It's also very printerfriendly with no overhangs and moderate printing time.

Print Instructions

• Print "Tray.stl" for every lower tray
• Print as many "Joint.stl" as needed to connect all the trays, one joint for two trays
• Print "TOP_Tray.stl" for the top tray when using suction cups
• Print "TOP.stl" for the endcap at the top Important: print the parts oriented as shown in the slic3r screenshots. See "Print Settings" for how to setup your slicer software.

Assembly

Note: print with 0.2mm layer height to have the parts fit together just right with only little force needed. Once connected they won't come apart without some extra force applied.

• Stick one "Joint.stl" into the top of the lowest "Tray.stl"
• Push the bottom of one "Tray.stl" onto the joint. If it is the topmost tray and you want to use suction cups, use "TOP_Tray.stl"
• Optional: put some silicon feet on the bottom of the lowest tray to allow water to flow out underneath
• Optional: slide two suction cups into the slots of the "TOP_tray.stl" as seen in the pictures. The slots are 9mm wide
• Put the endcap "TOP.stl" into the top tray

  Print Settings

Printer Brand:

Prusa

Printer:

i3 MK2S

No

Supports:

No

0.2mm

Infill:

25% Rectilinear

Notes:

Disable supports in your slicer software, it might calculate some for the "Joint.stl" which are not needed.

• Layer/First Layer Height: 0.2mm
• Vertical Shells: 3
• Solid Layers Top/Bottom: 3
• Seam position: rear
• All "Quality" settings except "Avoid crossing perimeters"