Table Saw Stock Guides

Diy table saw stock guides similar to the JessEm Clear Cut.
22
42
0
581
updated May 19, 2024

Description

PDF

A DIY set of table saw stock guides that are similar to the Clear Cut guides from JessEm. These run on a T-track that is secured to your table saw fence and are angled to help direct the stock into the fence, help hold it down, and thanks to the one way bearings possibly help with kickback. This was designed around my Ridgid R4560 table saw (identical to delta TS725-T2) but should fit most contractor/cabinet saws with few changes. I did not design a wheel for this since i reused one from a Aliexpress set i already had, 3d printed one could be designed easily. The T-track nuts, knobs, and wheel mount hardware were also reused from the Aliexpress set. For the spring, use any spring with a 6mm or ¼" id that is stiff enough and an appropriate length M6 bolt.

 

Required Hardware for 1 guide:

  • 1   One way wheel, i used these from Aliexpress
  • 1   5/8" steel round bar, cut to 6" long with a M6 or ¼" hole drilled and tapped on one end
  • 1   M5 nut for pivot arm clamp
  • 1   M5x10 screw or knob for pivot arm clamp
  • 2  3mm ID flanged ball bearings (McMaster Link) for pivot
  • 1   M3 nylock nut for pivot
  • 1   M3x40 screw for the pivot shaft
  • 2  M6 Nuts, one for the base, one for the wheel arm
  • 1   M6 bolt to mount the wheel
  • 1   M6 or ¼" fender washer for the spring
  • 1   Spring
  • 1   M6 bolt for Spring
  • 2   T-Track nuts
  • 2   T-Track bolts/knobs

Tags



Model origin

The author marked this model as their own original creation.

License