This is a pen holder for my Rocketbook Fusion Executive notebook. I had an elastic band pen holder that I liked, but it was a little too flimsy. It's also important to note that the slot for the pen was designed around this PILOT FriXion Ball LX Pen that I purchased from Amazon.
I have not printed the completed item yet, because I'm in the process of installing a BLTouch on my Ender 3 (#firmware-hell). That being said I'm also at a bit of a loss for how best to orient this print. I'm open for any suggestions y'all may have!
Category: OfficeThe author marked this model as their own original creation. Imported from Thingiverse.