Microscope (G600) arm attachment (Microphone stand)

This is an attachment that you can print to fit a G600 microscope to this microphone desk clamp/stand: https://www.amazon.nl/dp/B01N0IYZVE/?th=1

Print the Clamp twice, as you'll need one on the top and bottom.

There's 2 versions of the Pivot, only difference is a slightly wider slot for the square nuts to fit in, but you'll only need to print one of them.

Additionally you'll need 4x m3x8mm screws and 4x M3 square nuts.

You can re-use the rest from the original mic holder.