Toothbrush Holder

This is a simple toothbrush holder that can store one toothbrush on each side and toothpaste in the middle - a useful design for 2-person bathroom where there are two sinks. I redesigned this from scratch in Fusion 360 following the design by PRSPR. An additional change was making a different base as many of the comments on PRSPR's design said the holder was easy to knock over out of the base. This base fits very snugly and will not be easily knocked over.

I printed this in Elegoo PETG on my Qidi X Smart-3. The base is a bit tight. I hit the bottom .25 inch (~7 cm) of the body with 400 grit sandpaper and it slid right in. You will need to reorient prints so they print with the bottom of the model on the bed.

My settings:

• Base
  • Bed temp: 80
  • Nozzle temp: 240 1st, 250
  • Infill: 25% grid
  • 0.2mm layer height
  • 3 vertical perimeters, top, bottom layers
  • No supports needed
  • Print time: 1h33m
• Body
  • Bed temp: 80
  • Nozzle temp: 240 1st, 250
  • Infill: 15% grid
  • 0.4mm layer height (reduced print time by 2 hours)
  • 6 vertical perimeters, 5 top, 3 bottom layers
  • No supports needed
  • Print time: 6h10m

BTW, This is my first print designed in Fusion 360 (I usually use Tinkercad)!

I redesigned this to have a different base (to solve the wobble problem stated in the comments) and to place the toothbrush holes on each side - useful for those who have 2 sinks.