Towel Rail Bracket 30 x 15 Oval Bracket Airing Cupboard Rail Holder

Towel Rail Bracket 30 x 15 Oval Bracket Airing Cupboard Rail Holder

I designed these holders to replace an old tired over the door towel rail for in my airing cupboard. 

 I used PLA+ printed with 0.2 layer height, 4 perimeters with 20% infil on my Ender 3.

Towel Rail is a 30x15mm oval clothes rail cut to size to suit from Screwfix 

I designed the piece with a 0.1-0.2mm tolerance. The rail needs pushing/knocking into the bracket with a hammer and piece of wood to protect the rail/bracket. 

4mm screws, length to suit requirement. I tried to recess the flat of where the screw are to make them more flush/hidden. due to the thickness i did not countersink the design. 

LH and RH models uploaded - these are just mirrored exports.

Not for comerical use