Cotton Candy Monster

AVAILABLE FOR COMMERCIAL RESALE WITH TIER 2 - V2 FRAME ONLY

 This model was sponsored by Polymaker so I wanted to make something that really popped and was different from other hueforge models. The depth on this one is pretty wild and is one of my favorites to date.  This complex color/low waste model uses 8 different Polymaker colors (13 instances). AMS/MMU not needed. Manual filament swaps can easily be done with pauses. This model will only be available to club members.

I have included 2 different 3MF files for Bambu Studio. One for people with an AMS unit, and one for people with NO AMS with pauses already set (manual color changes). I used 2 AMS units to print this, and it definitely made it easy as many colors are reused. You can assign slots for 1 AMS and do manual spool swaps if you are up to it. Just pay attention to your color order and use the “Pro Tip” below.  If you do not have Bambu Studio I recommend using it to look through the settings and copying them to make a Hueforge profile template for yourself in your slicer of choice so that future prints will be quick.  

Pro Tip: If you are using more colors than you have AMS units you can manually unload the last spool after the print starts. With 1 AMS when it gets to slot 4 in the print it will error and force a pause. You can then load the new colors (5-7) in AMS slots 1-3 then put color 4 back in and repeat this process by unloading color 4 when it is complete it will pause when it is time for color 8. With 2 AMS you can do the same above just with AMS slot 8. It will pause at 8 then you can load colors 9-12 into your AMS slots 1-4. You don't have to let it force pause if you make it back in time to swap. This is handy if you are worried about missing the timing of a spool swaps.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. The profiles have a height modifier to print the first 0.64mm @ 0.16 layer height as that is the min depth/non blended portion of the base color. If you don't use my 3MF set all your color changes before doing the modifier as it changes the amount of layers. This shaves off approximately half an hour of print time. If you have any questions about printing this hit me up. 

Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA PolyLite Blue Transmission Distance: 1
PLA PolyLite White Transmission Distance: 5
PLA PolyLite Aqua Blue Transmission Distance: 2.5
PLA PolyLite Purple Transmission Distance: 0.5
PLA PolyTerra Sakura Pink Transmission Distance: 2.8
PLA PolyTerra Savannah Yellow Transmission Distance: 3.5
PLA PolyLite Pro Metallic Magenta Transmission Distance: 1
This print uses 8 unique filaments

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Blue
At layer #12 (1.04mm) swap to White
At layer #15 (1.28mm) swap to Aqua Blue
At layer #16 (1.36mm) swap to Purple
At layer #21 (1.76mm) swap to Sakura Pink
At layer #25 (2.08mm) swap to White
At layer #28 (2.32mm) swap to Savannah Yellow
At layer #31 (2.56mm) swap to White
At layer #35 (2.88mm) swap to Black
At layer #37 (3.04mm) swap to Metallic Magenta
At layer #41 (3.36mm) swap to Sakura Pink
At layer #45 (3.68mm) swap to White for the rest.