Frosthaven Condition Tokens

Why did I make these? Because I own a 3d printer, no better reason than that.

The tokens are 15mm in diameter and 3mm high. They are designed to be filled with epoxy resin (that's why they look shiny in the photo).

Using prusa slicer: I first printed the base of the token in an appropriate color or printed the base a close color and then painted the bases while still on the build plate without removing the build plate from the bed. Filament has no problem adhering to the paint.

Then I printed the tops by using a 1mm Z offset (the bases are 1mm thick) with a travel lift of 2mm set to only lift when below 1.2mm. This avoids any collisions with the previously printed base.

Each token will hold approximately 0.3 - 0.5ml of resin. I mixed up 40mls total of resin and that was enough for over 80 tokens including wastage.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill: